Sonnet-technologies Encore_ZIF 1.0 GHz Processor Upgrade Instrukcja Użytkownika Pobierz pdf (Strona 24)

Figure 79

Figure 80

Hardware Installation—G3 Blue & White, G4 PCI Graphics

4. While applying moderate pressure on top of the Encore/ZIF

card’s heat sink above the ZIF socket, secure the card in place by

pressing down on the ZIF socket lever until it latches under the

socket’s side tab (Figure 77).

Install Jumper Blocks

Install the four small jumper blocks included with the Encore/ZIF

card in the positions shown (Figure 78); verify the jumper blocks

are installed onto the pins, not between them.

Install Power Adapter Cable Between Computer and

Encore/ZIF Card

1. Locate the logic board power cable plugged in next to the PCI

slots (Figure 79). Unplug the connector by pulling it straight up

while squeezing its locking tab.

2. Plug in the provided power adapter cable between the connector

on the logic board and the logic board power cable (Figure 80);

verify that all the connectors are plugged in securely.

WARNING: When disconnecting cables from the logic board,

do not pull on the wires; always pull on the connectors.

power cable

connector

power cable

connector

adapter cable

connector

adapter cable

connector

Figure 77

Figure 78

Encore/ZIF card

lever

replacement jumper

blocks

jumper positions

1 2 ... 19 20 21 22 23 24 25 26 27 28

Brak uwag

Sonnet-technologies Encore_ZIF 1.0 GHz Processor Upgrade Instrukcja Użytkownika Strona 24